Test fields in an existing draft from the retired Tradie Forms NSW CCEW
Record the tests you actually did on site. Tick a test only if you performed it with the right equipment and the standards that apply to your work.
The test date should reflect when safety tests were actually performed:
Use the calendar picker or quick buttons ("Yesterday", "Today") to set the test date.
Complete testing before certifying the installation so the report matches the final condition of the job.
The draft does not accept a future test date. Pick the actual date the tests were completed, not the eCert submission date unless they coincide.
Use "Check All" only when every listed test applies and was completed. Otherwise, choose the individual tests that match the job.
Earthing system integrity
Records earthing continuity and connection checks.
Residual current device operational
Records RCD or safety switch operation checks.
Insulation resistance (MΩ)
Records conductor insulation resistance readings. Use the threshold that applies to the job and standard.
Visual check suitability of installation
Records the visual inspection of equipment, environment, wiring, and visible defects.
Polarity verification
Records active, neutral, and earth connection checks.
Stand-alone system compliance
Records checks for off-grid or isolated power systems where they apply.
Connection integrity
Records connection and termination checks.
Fault loop impedance
Records fault loop impedance readings where this test applies.
Certification section
Declaration and current eCert submission.